40
ENGLISH
Primer equipped vehicles
Starting the engine: To prime, activate button until a pumping resistance is felt.
From this point, pump 2 or 3 times to inject fuel in intake manifold.
After priming, ensure that primer button is pushed back.
NOTE:In very cold temperature, it is recommended to rotate primer button 3-4
turns prior to pull it. This will eliminate the possibility of sticking.
NOTE:Priming is not necessary when engine is warm.
Choke equipped vehicles
Initial cold starting:Do not operate the throttle lever with the choke lever on.
When temperature is below -10°C
Move the choke lever to position 2 and start the engine. As soon as the engine
starts move the lever to position 1. After a few seconds (max.10 seconds) move
the choke lever to OFF position.
NOTE:In severe cold weather, colder than -20°C you may need to flip choke
lever from OFF to position 1 a couple of times once engine is started.
0. OFF
1. Position 1
2. Position 2
When temperature is above -10°C
Move the choke lever to position 1.
Grab the handle firmly and start the engine or electric starter if it is equipped.
As soon as the engine starts move the choke lever to OFF.
To Next Page
Loading...
Need help?
General
