EasyManuals Logo

Lynx Forest Fox User Manual

Lynx Forest Fox
73 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #49 background imageLoading...
Page #49 background image
48
ENGLISH
Engine oil level
Yeti V-1300: Make sure engine is at operating temperature. Snowmobile must be
on a level surface. Leave engine running at idle for 30 seconds. Stop engine and
wipe off the oil from the dipstick. Dipstick must be completely screwed in before
checking oil level. Oil level must be between minimum and maximum marks on
dipstick. The amount of oil between lower and full marks are 0,5 liter.
1. Lower level mark
3. Full level mark
V-810 engine type: Before checking the oil level the engine must be shut down
for 5 minutes. Snowmobile must be on a level surface. Pull out the dipstick and
wipe off the oil from the dipstick with a suitable rag or paper. Put the dipstick back
and pull out it again, check the oil level and fill if it is necessary. There are
capacity of 0,5 liter oil between lower and full mark.
1. Full level mark
2. Lower level mark
Add Bombardier synthetic oil OW4O through dipstick hole as required.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lynx Forest Fox and is the answer not in the manual?

Lynx Forest Fox Specifications

General IconGeneral
BrandLynx
ModelForest Fox
CategoryOffroad Vehicle
LanguageEnglish

Related product manuals