Lynx S-30 User Manual

Step 5
• Then connect part 3 and H-shape stand. First, position the extension of part 3 into the squares holes on
H-stand. Second, insert the screws and washers into the holes besides the squares then tighten them (Figure 2-5).
Step 6
• Remove the cutting plotter from the carton. Position your stand under the plotter, then insert the screws
into the holes on plotter’s bottom. In order to make the task easier, you may need someone to help you.
Figure 2-5
Figure 2-6
Extension
Square holes
Screws holes
3
2. Installation 2-4

Lynx S-30 Specifications

General

Brand	Lynx
Model	S-30
Category	Cutter
Language	English