63
You can also use other Sequence Mode options to erase all steps for a single pad or to erase
all steps from the entire Sequence.
To erase all steps for a single pad:
1. Enter Sequence Mode by pressing the Sequence Mode (Seq) button.
2. Check above the third Function Button (Page) to make sure you are viewing Page 1. If
you are on Page 2, press the button to move to Page 1.
3. Press the second Function Button (Edit Velocity).
4. Press the pad whose steps you want to erase. The pad number will appear in the display,
and any steps for that pad in that bar will appear in the Step Switches.
5. To erase all steps for that pad, press the second Function Button (Clr Pad). Be careful—
this cannot be undone!
6. Make other changes, or exit Sequence Mode by pressing the Sequence Mode (Seq)
button or fourth Function Button (Exit) twice.
1: 2: 3: 4:
127 00 00 00
BANK:A PAD:A01 BAR:Auto VEL:127 CLR PAD CLR ALL EXIT TIE
5: 6: 7: 8:
00 00 00 00
9: 10: 11: 12:
127 00 00 00
13: 14: 15: 16:
00 00 00 00
To Next Page
Loading...
