MAEVING RM1 - Page 57

57
TYRES
13. Remove the 2 bolts securing the brake caliper and detach the
rear brake caliper from the swinging arm.
Note: When refitting, tighten to 18 Nm.
14. Secure the brake caliper to one side, using string or a retaining
strap.
15. Undo, but do not remove, both axle nuts on the rear wheel axle.
Note: Left-hand shown, right-hand similar.
Note: When refitting, tighten to 100 Nm.
16. Remove both rear wheel securing plate bolts.
Note: Left-hand shown, right-hand similar.
Note: When refitting, tighten to 35 Nm.
Caution: Make sure the rear wheel motor wiring harness
is not trapped or damaged while the rear wheel and motor
assembly is being removed.
! ! !
! ! !
! ! !
! ! !
! ! !
! ! !
15
16
13