Maeving | RM1 Owner’s Handbook
56
TYRES
9. Reposition the electrical connector’s protective cover, release
the electrical connector's retaining device and disconnect the
electrical connector.
10. Remove the 3 bolts securing the 3 main power cables to the
electric motor control module and disconnect the 3 main power
cables.
Note: When refitting, tighten to 5 Nm.
11. Cut the 2 retaining straps securing the rear wheel motor wiring
harness to the swinging arm.
Note: Fit new retaining straps when reattaching the rear
wheel motor wiring harness to the motorcycle.
12. Carefully reposition the rear wheel motor wiring harness away
from the components in the electronics housing.
Caution: Make sure the rear wheel motor wiring harness
is not trapped or damaged while the rear wheel and motor
assembly is being removed.
Caution: Make sure the rear brake caliper and brake hose
are not trapped or damaged while the rear wheel and motor
assembly is being removed.
Caution: Do not let the rear brake caliper hang by its hose.
10
9
12
11
To Next Page
Loading...