MAEVING RM1S 2024 - Installing the Battery

41
BATTERY
Installing the battery
CAUTION: : Always take care when
refitting the primary battery, paying
particular attention to your standing
position before lifting the battery. If
not correctly positioned, you could
sustain an injury.
CAUTION: Make sure to have a firm
grip of the battery handle before
attempting to refit the battery. Failure
to do so may result in personal injury.
NOTICE: Make sure to have a firm
grip of the battery handle before
attempting to refit the battery. Failure
to do so may result in damage to the
battery and/or motorcycle.
Note: When using a single battery,
it must be installed in the primary
battery location in the lower position
of the battery compartment.
Note: The motorcycle will not allow
drive mode to be selected if only
the secondary battery is installed
in the upper position of the battery
compartment.
1. Open the battery compartment. For
further information, see Battery
compartment on page 37.
Note: Make sure the ignition key is in
the OFF position before installing the
primary or secondary battery.
2. Using the carry handle, carefully
lift the primary battery and align it
with the lower position in the battery
compartment before inserting it.
Note: The LED indicator on the
battery must be on the bottom right
side of the battery, as shown.
3. Carefully slide the battery into position,
making sure that the battery fully
engages with the connector (1).
4. Push the handle flat and close the
battery compartment (2
).
For further information, see Removing and
installing a battery on page 40.
Note: Use the process above to
install the primary or secondary
battery.
! ! !
! ! !
!
! ! !
! ! !
! ! !
! ! !
! ! !
1
2