87
12-VOLT BATTERY
12-volt battery removal and installation
WARNING: Batteries are hazardous. Before handling the
batteries, make sure you read and understand all of the
warnings given in Battery handling safety on page 36.
Failure to comply with the warnings increases the risk of
injury, death, or damage to the motorcycle or property.
WARNING: The electric motorcycle components should
only be serviced by qualified personnel. Specialist tools and
personal protective equipment are required for working on
any electric vehicle. Unqualified personnel can potentially
cause serious personal injury or death.
NOTICE: The batteries should be stored at moderate
temperatures and in dry conditions. Failure to store the
batteries in the correct conditions could cause damage to the
batteries and cause them to lose their charge-holding ability.
To remove the 12-volt battery:
1. Make sure the ignition key is in the OFF position.
2. Remove the 12-volt battery access panel. For further
information, see 12-volt battery access panel removal on
page 85.
3. Disconnect the negative (-) and positive (+) battery connectors.
4. Remove the 2 screws (T30 Torx™) and battery retaining bracket,
and remove the 12-volt battery.
Note: The installation procedure is the reverse of removal.
Note: When refitting, tighten to 8 Nm.
4
3
To Next Page
Loading...
