MAEVING RM1S 2024 - Brake Pad and Brake Disc Wear; Inspection

67
MAINTENANCE AND ADJUSTMENT
Brake pad and brake disc wear
inspection
Inspect the brake pads and discs in
accordance with the maintenance schedule.
If the brake pads are worn to or below the
minimum service thickness of 1.5mm of
friction material, the brake pads should be
replaced.
If the brake discs are worn to or below the
minimum service thickness of 3.5mm, the
brake discs should be replaced.
If the brake pads and/or brake discs need
to be replaced, please contact the Maeving
Workshop Team, a Maeving Workshop
Partner or a qualified person or business
with an extensive technical knowledge of
motorcycles. For further information, see
Contacts on page 6.
WARNING: Brake pad wear beyond
the recommended friction limit will
result in contact of the metal support
with the brake disc, resulting in
damage/wear to the brake disc and
compromising braking eciency and
the safety of the rider. Riding with
worn brake pads/discs may lead
to loss of control and an accident,
causing injury or death.
WARNING: The front and rear
calipers both contain two brake
pads and must always be replaced
as a pair. Never replace individual
brake pads, as this will compromise
braking eciency and may lead to an
accident, causing injury or death.
Note: Do not ride the motorcycle
with defective or worn brake pads/
discs, as doing so may lead to costly
repairs and/or void the warranty.
! ! !
! ! !
! ! !