MAEVING RM1S 2024 - Page 46

Maeving | RM1S Owner’s Handbook
46
BATTERY
6. Leave the battery on the charging
dock until it is either fully charged or
suciently charged for your next trip.
Once the battery is fully charged, the
battery charger will stop charging.
The battery’s LED display confirms
the current State of Charge (SoC), and
each LED flashes until the next charge
increment has been achieved.
The definition of the LED state is as
follows:
a. Green (flashing) - The battery is
charging.
b. Once charging is complete, the LED
gauge will switch o.
7. The SoC can be checked when the
battery is not installed in the motorcycle
by pressing the small button on the top
of the battery.
The SoC is shown on the indicator display.
For further information, see Checking the
battery is charged on page 38.
8. Once the battery has sucient charge,
turn the battery charger o at the mains.
9. Place your foot on the foot plate in the
centre of the charging dock and lift the
battery o the charging dock using the
carry handle.
Note: Additional battery chargers
and charging dock units can be
purchased on the Maeving website.
For further information, please visit
www.maeving.com.
! ! !