28 Programming Guide
Communication Programming
Section [800]: Dialer Options OFF ON
[1] & [2]
N See Table N See Table
[3] Switch to pulse on 5
th
attempt
N Disabled N Enabled
[4] Alternate dial
N Disabled N Enabled
[5] Force dial
N Disabled N Enabled
[6] DTMF dialing
N Disabled N Enabled
[7] Pulse ratio
N1:2 N 1:1.5
[8] N/A N/A N/A
Section [801]: Dialer Options OFF ON
[1] Report system disarming
N Always N After alarm
[2] Report zone restore
N Bell cutoff N Zone closure
[3] to [8] N/A N/A N/A
Section [802]: Event Call Direction Options 1 OFF ON
[1] Call tel. #1 for arm/disarm reporting codes
N Disabled N Enabled
[2] Call tel. #2 for arm/disarm reporting code
N Disabled N Enabled
[3] Call pager for arm/disarm reporting codes
N Disabled N Enabled
[4] N/A N/A N/A
[5] Call tel. #1 for alarm/restore reporting codes
N Disabled N Enabled
[6] Call tel. #2 for alarm/restore reporting codes
N Disabled N Enabled
[7] Call pager for alarm/restore reporting codes
N Disabled N Enabled
[8] N/A N/A N/A
Section [803]: Event Call Direction Options 2 OFF ON
[1] Call tel. #1 for tamper/restore reporting codes
N Disabled N Enabled
[2] Call tel. #2 for tamper/restore reporting codes
N Disabled N Enabled
[3] Call pager for tamper/restore reporting codes
N Disabled N Enabled
[4] N/A N/A N/A
[5] Call tel. #1 for trouble/restore reporting codes
N Disabled N Enabled
[6] Call tel. #2 for trouble/restore reporting codes
N Disabled N Enabled
[7] Call pager for trouble/restore reporting codes
N Disabled N Enabled
[8] N/A N/A N/A
Telephone Line Monitoring (TLM) Options
[1] [2]
OFF OFF Disabled
OFF ON When disarmed: Trouble only
When armed: Trouble only
ON OFF When disarmed: Trouble only
When armed: Audible alarm
ON ON Silent alarms become Audible alarm