COIL COOKTOP
Cooktop Indicator Lights
Freestandingrangeswitha coil-type cooktopwillfeature Rangesare equippedwithtwo indicatorlightswhich glow
an "upswept" oooktop. The cooktop on a Canadian when a surface element is on. The indicator light will
freestanding range does NOT lift up. remainon until the element is turned off. After a cooking
operation, be surethe element and indicatorlightare off.
To raisethe "upswept" cooktop:When cool,graspthe
frontedge ofthe cooktopand gentlylift up untilthetwo
supportrodsat thefrontof the cooktopsnap intoplace. Drip Bowls
__ • Be sure drip bowls, located under each element, are
in place.
• Absence of these bowls during cooking may subject
wiring or component parts underneath the cooktop to
damage.
• To prevent risk of electric shock orfire, do not line drip
bowlswithaluminum foil.
Tolowerthetop: Holdthefrontedgeofthe cooktopand Yourrange willbe equippedwith eitherchromeplated
carefullypushback on each supportrodto releasethe steeldripbowlsor porcelaincoatedsteeldripbowls,
notchedsupport.Then gentlylowerthe top into place.
The support rods willslide intothe rangeframe. Chrome drip bowls will turn blue or gold over time if
overheated. This type ofdiscoloration ispermanent and
Surface Elements will notaffect the cookingperformance.
• Surfaceelementsare self-cleaning. To protectthe porcelaincoatedsteelfinish, avoidusing
highsettings for long periods of time. Reduceto a lower
• Do not immerse elements in water, setting oncefood begins cooking. Do not use oversized
• When an element is turned on, itwill cycle on and off cookware. Pan should not extend more than 2 inches
to maintain the heat setting, from the element.
• To preventdamage tothe range, NEVERoperate the Clean bowls after each use with soap and water.
surface element without a pan in place and NEVER Remove stubborn stains with baking soda paste and
allow a panto boil dry. plastic scouring pad or a mild cleanser. To prevent
scratching the finish, do not use abrasive cleaning
andC°°l'T°andcarefullyrem°Ve:awayraisefromelementpulIWhentheOut _,___ agents. Rinse,dry and replace.
receptacle.
To replace: Insert the terminals on the element into the
receptacle. Gently lift up on outer edge of element
(opposite terminal-side of element) while inserting
terminals into receptacle. Gently press down on outer
edge of element until element sits level on drip bowl.
Be sure drip bowl and chrome trim ring,if equipped, are
properlyinstalled. The notch on the trim ring should be
centered over the screw securing the receptacle to the
maintop, if trim ring is not installed properly and rests on
this screw, the trim ring and drip bowl will "rock".
PAGE 10
To Next Page
Loading...
