SERVICE INFORMATION
Explanation Of Fault Codes Adjusting Oven Temperature
Your appliance is equipped with an electronic control Your new appliance has been factory tested for oven
featuring built-in, self-diagnostic software. This temperature accuracy. Even though your range has
software continuouslymonitors the control to insure safe been tested, you may find that the cooking results with
and proper operation. If the software should detect a your new oven are different from your previous oven.
questionable situation, a FAULT CODE (F plus a
number) will appear in the display and continuousbeeps If you have carefully followed the recipe, reviewed the
may sound, bakingtips on page 14andstillfeel cookingresultsdo not
meet your expectations, you can adjust the oven
temperature. DO NOT ADJUST THE TEMPERATUREif
only one or two items are not baking properly.
I I _ Ifyou thinkthe oven should be hotteror cooler, you can
i-- -- SET adjust it yourself. To decide how much to change the
I__ thermostat, set the oven temperature 25°F higher or
lower thanthe temperature called for in your recipe,then
bake.The results ofthe "test" should giveyou an ideaof
how much to adjust the thermostat.
A fault code indicates that there may be a functional To adjust the thermostat:
error. As a safety precaution, the control will
1. Pressthe OVENTEMP pad.
automatically cancel the program.
2. Turn the SET knob until 550° is displayed.
During Normal Oven Cooking 3. Press and hold the OVEN TEMP pad for several
If a fault code appears in the display and continuous secondsuntil00° appearsinthe display.
beeps sound, press the STOP/CLEAR pad. Then,
reprogramthe cookingoperation. If 00° does not appear in the display,pressthe
STOP/CLEARpadand beginagain.
If the fault code reappears in the display, call an
authorizedservicer.Do notuse the ovenuntilthe range If the oventemperaturewas previouslyadjusted,
has beenserviced.The cooktopcan be used. the change will be displayed.For example, if the
temperature was reduced by 15°, -15° will be
displayed.
During A Self-Clean Cycle 4. Turn the SET knobtoselectthetemperaturechange
Iftheovenisheavilysoiled,excessivesmokeandflaring desired.
may result in a fault code. If this occurs,press the
STOP/CLEARpadandallowtheoventocoolforanhour. • The oventemperaturecan be increasedup to35°
Then, reprogramthe ovenforthe cleancycle, or reduced by as much as 35° (-35 °) in 5°
increments.
If the fault code reappears in the display, call an
authorizedservicer.Do notusethe ovenuntilthe range NOTE: If youdelayin selectinga temperature,the
has beenserviced.The cooktopcan be used. program will automaticallycancel and 00° will
disappear.Beginagainif the programcancels.
5. Pressthe STOP/CLEARpadand thetimeof day will
reappearinthedisplay.The ovenwillnowbakeatthe
adjustedtemperature.
Itis notnecessaryto readjustthe oventemperatureif
thereisa powerinterruption.Thisadjustmentwillnot
affectbroil,cleanor SpeedCook operations.
PAGE 28
To Next Page
Loading...
