Form 07A –Frontier V6, V4 and Extreme X8 Owner’s Manual ENGLISH.docx Revision No.4
© Magic Mobility Page 22 of 65
Drive the tilt function forwards until it stops in the home position;
Drive the recline function forwards until it stops in the home position;
If your chair is still inhibited, refer to the Common Troubleshooting section and follow
instructions for your particular Joystick Module
5.9 Steering lock option - if fitted (Extreme X8 only)
The purpose of the steering lock is to provide greater straight-line directional stability. This is
particularly useful when reversing the wheelchair down-ramps out of a vehicle. This is achieved by
locking the steering tie-rod and is engaged by the chair operator via the joystick
Bring your power chair to a complete stop on a flat level surface.
Push the ‘Mode’ button on the joystick. Select the Steering lock option by moving the joystick
left or right. Once the Steering lock option is highlighted (as shown to the right), moving the
joystick forward or backwards will operate the function.
Once the steering lock is engaged; release the joystick at this point.
Before driving normally, ensure that you have disengaged the steering lock with the joystick
WARNING! When the steering lock is engaged, only drive the wheelchair forwards
and backwards. Attempting to drive the wheelchair normally with the steering lock
engaged could cause serious damage.
To Next Page
Loading...
Need help?
General
