Form 07A –Frontier V6, V4 and Extreme X8 Owner’s Manual ENGLISH.docx Revision No.4
© Magic Mobility Page 8 of 65
WARNING! Avoid putting all your weight on either armrests or footrests. This may
cause the power chair to tip and cause injury
3.2 Motor Vehicle Transport
Wheelchair positioning belts are not designed with the intent of providing proper restraint during
motor vehicle transportation. An ISO 7176-19 compliant system is available from Magic Mobility.
All Magic Mobility electric wheelchairs have been tested to and conform to the requirements of ISO
7176-19. The Frontier V6 Mid Wheel Drive and Extreme X8 also comply with the requirements of
ANRI/RESNA WC/19; further details of this are available on request.
For detailed information see Appendix A – ISO 7176-19
NOTE: ISO = International Organisation for Standardisation
WARNING! Whenever feasible, wheelchair users should transfer to the vehicle seat
and use vehicle manufacturer installed restraint system.
WARNING! The primary goal of ISO 7176-19 is to reduce the potential for injury to
wheelchair seated occupants in the event of a vehicle impact. Modifications or
additions to the wheelchair (changes to the frame, aftermarket cushions, harnesses)
may reduce its safety in a vehicle accident. If unsure of their effect, please consult a
suitably qualified professional for advice.
3.3 Weight Limitations
Your power chair is rated for a maximum weight capacity of 182 kg/400 lbs (see table). Do not
carry passengers or heavy weights on any part of the wheelchair.
Seat elevator or tilt fitted
STOP! Exceeding the weight capacity voids your warranty and may result in damage
to your power chair.
To Next Page
Loading...
Need help?
General
