Form 07A –Frontier V6, V4 and Extreme X8 Owner’s Manual ENGLISH.docx Revision No.4
© Magic Mobility Page 23 of 65
6 Joystick controls
The joystick controls may be customised and may be one of a number of different models depending
upon users requirements. This manual contains information on the standard joystick control.
6.1 Joystick
This controls the speed and direction of the wheelchair. Push the joystick in the direction you wish to
go. The further you push it, the faster the speed. Releasing the joystick stops the wheelchair and
automatically applies the brakes.
6.2 Joystick power
If the power chair begins to move in an unexpected manner, immediately release the joystick and
turn the wheelchair off. Unless the joystick is damaged, this should stop your power chair.
If the joystick is not in the neutral (centre) position when you turn on the power, you may cause a
fault in the system. Releasing the joystick and turning the power off and on again will reset the
system.
WARNING! Always turn the power off when you are stationary to prevent
unexpected movement.
6.3 Rain and Water
The joystick hand control unit IS NOT WATERPROOF. The joystick module is splash proof but may
be permanently damaged if water transgresses the rubber seals (this damage is not covered under
warranty).
We recommend carrying a plastic bag large enough to cover the joystick module and the user’s
hand, in case of rain.
6.4 Joystick lead
If for any reason, the joystick lead is disconnected take care when reconnecting, do not force the
plug into the socket. The lead is polarised and should only be fitted one way.
STOP! Forcing the plug into the socket the wrong way can permanently damage the
electronics system. Also, do not place the lead so that it can be pinched in the seat
frame or the power base frame.
6.5 Controller program
The controller program affects speed, acceleration, deceleration, and braking. The drive mode
settings are pre-set at the factory. If your Magic Mobility Dealer changes these settings, please
make note of these changes.
WARNING! Do not attempt to reprogram your chair. Only the power chair
manufacturer, an authorised representative of the manufacturer, or a trained service
technician should program the controller.
To Next Page
Loading...
Need help?
General
