Enter the CJSM2 Setting menu, and select Bluetooth. Pre-
programmed device names should appear.
Magic has pre-programmed the following:
iPad
iPhone
PC
Android Device
(Press and hold the top left hand Screen Button (Hazard key) for 1
second to enter the settings menu)
To start the pairing process, turn the device On by deflecting the
joystick to the right.
After turning a device On, power cycle the controller
Select the item you want to pair to by scrolling down, a right
deflection selects the device
6.9.5
Discovery Mode
Deflect the joystick forward for 10 seconds until it beeps, then deflect the Joystick backwards until it
beeps. There should now be a flashing Bluetooth icon on the CJSM2 display. This means the CJSM2
is discoverable.
Select the device (e.g. Tom’s iPad) to be connected and search for Bluetooth devices, this will start
the connection to R-net. Once connection is successful, “Tom’s iPad” will appear in the connected
devices window and navigation of the iPad will be possible using the R-net CJSM2-BT.
To connect to an additional device (e.g. Tom’s PC), select the device and repeat the above process.
Up to four devices can be connected.
Selecting different connected devices
Once the devices are paired they will remain connected to R-net. On entering “My Devices” mode,
the last device connected will always be the option highlighted in the menu. To select a different
device scroll to the desired device and deflect the joystick either right or left. After a couple of
seconds, a static Bluetooth icon will appear on the CJSM2 screen and navigation of the new device
can commence.
Disabling Connected Devices
To disable a connected device and remove it from the menu displayed in “My Devices”, Select
Bluetooth in the setting menu, the devices can be disabled through a right deflection of the joystick.
Note re-pairing is not required if the device is subsequently turned on.
To Next Page
Loading...
Need help?
General
