Form 07A –Frontier V6, V4 and Extreme X8 Owner’s Manual ENGLISH.docx Revision No.4
© Magic Mobility Page 63 of 65
The wheelchair complies with the requirements of ISO 7176-19:2008 and, as such has
been designed and tested for use only as a forward facing seat in motor vehicles
The wheelchair has been dynamically tested in a forward facing orientation with the ATD
restrained by both pelvic and shoulder belts (e.g. a shoulder belt as part of a three point
belt restraint)
Both pelvic and shoulder belt restraints should be used to reduce the possibility of head
and chest impacts with vehicle components
In order to reduce the potential of injury to vehicle occupants, wheelchair mounted trays
not specifically designed for crash safety should
1) Be removed and secured separately in the vehicle, or
2) Be secured to the wheelchair but positioned away from the occupant with energy
absorbing padding placed between the tray and the occupant
When possible, other auxiliary wheelchair equipment should either be secured to the
wheelchair or removed from the wheelchair and secured in the vehicle during travel, so
that it does not break free and cause injury to vehicle occupants in the event of a collision
The wheelchair should be inspected by a manufacturer’s representative before reuse
following involvement in any type of vehicle collision
Alterations or substitutions should not be made to the wheelchair securement points or
to structural and frame part or components without consulting Magic Mobility
Spill proof batteries such as gelled electrolyte should be installed on powered wheelchairs
when used in a motor vehicle
Care should be taken when applying the occupant restraint to position the seat buckle so
that the release button will not be contacted by wheelchair components during a crash
To Next Page
Loading...
Need help?
General
