34
Path: enter the path under which the images should be stored on the FTP server.
Transfer mode: choose whether an active or passive FTP connection should be requested
when transmitting.
Upload at intervals: tick this option if you would like images from the security camera to
be uploaded to the FTP server at regular intervals.
Interval (seconds): specify here the intervals at which images should be captured and
transferred.
Specify file name: tick this option if you wish to specify a file name. If this option is not
ticked, a preset file name will be used for storing images.
File name: enter your own file name here. When images are stored, this name will be used
together with sequential number suffixes.
Specify maximum number: this option may be used in order to limit the number of files
stored on the FTP server.
Number of files: specify the maximum number of files to be stored on the FTP server.
When this number is reached, each additional image will be stored by deleting the oldest
image held at that moment.
To test the FTP settings, click “Test” below. This will then save a single image to the FTP
server.
Click “Save” to accept the changed settings. The changes to the FTP settings are accepted
without rebooting the camera.
To Next Page
Loading...
