42
60 Series 2WD/4WD, Model - 8560
PTO Speed Selection
PTO Speed Selection
Two speeds viz. 540 rpm and 1000 rpm are provided for the
PTO. These speeds can be achieved by reversing the PTO
shaft.
The PTO shaft consists of 6 splines on one end and
21 splines at the other end. This shaft can be detached after
removing the circlip (A) and can be refitted from either end.
1. Shaft fitment with 6 splines pointing towards the
implement gives you an output of 540 rpm at PTO.
2. Shaft fitment with 21 splines pointing towards the
implement gives you an output of 1000 rpm at PTO.
Always lock the shaft with circlip (A) after closing the
speedmode.
Firmly apply the parking brakes, place all
gearshift levers in neutral and block all four
wheels before operating any stationary PTO
equipment.
Do not approach or work on the PTO shaft or
equipment while the PTO is in motion.
Shut-off engine and the PTO and wait for all
movement to stop before working on the PTO
or equipment.
A
To Next Page
Loading...
Need help?
General
