4.19. Non-Contact AC Voltage Measurement
WARNING: Risk of Electrocution. Before use, always test the voltage
detector on a known live circuit to verify proper operation.
1. Touch the probe tip to the live conductor or insert into the live side of
the electrical outlet.
2. If AC voltage is present, the detector light will illuminate.
Note: The conductors in electrical cord sets are often twisted. For best
results, move the probe tip along a length of the cord to assure placing
the tip in close proximity to the live conductor.
Note: The detector is designed with high sensitivity. Static electricity or
other sources of energy may randomly activate the sensor. This is
normal operation.
16
OFF
V
Hz%
CAP
Ω
T
emp
°C
°F
600A
AC/DC TRMS
CLAMP METER
WITH DA
TALOGGER
1000A
CAT III 1000V
CAT IV 600V
CAP
V Hz%
Ω
T
emp
COM
AUTO POWER OFF
V
LoZ
ESC
Bluetooth
INRUSH
REL
RANGE
MENU
MODE
2sec.
10:18
V
0
Mode
Max
Menu
Auto
0
3
6
To Next Page
Loading...
