The first part identifies the features of the Accessory, for example the function
controls, connectors and indicators etc. The second part identifies the areas of the
Malvern software, which are pertinent to the Accessory.
Chapter 5 - How the Accessory works
After reading this chapter you will have a basic understanding of the operating
procedures of the Accessory and in particular:
.
Know the basic operating principle.
.
Know the simple steps involved in using the Accessory when making a
measurement.
Chapter 6 - Making a measurement using the Accessory
This chapter will guide you through the practical steps involved when making a
measurement using the Accessory. Reference is made to the Getting Started
manual which provides detailed information regarding the system.
Chapter 7 - Creating & changing SOP’s
This chapter will give details on how you can create and maintain your own
Standard Operating Procedures.
Chapter 8 - Sample preparation
This chapter, in conjunction with chapter 9 of the Getting Started manual,
provides you with information on one of the most important stages in making a
measurement. It provides you with specific sample preparation requirements
pertinent to the Accessory.
Chapter 9 - Maintenance
This chapter provides information on certain maintenance routines that can be
carried out by the user. These include cleaning the Accessory, changing the fuses
etc. After reading the “Access to the Accessory” section earlier in this chapter, you
should now be aware of what the Supervisor and the Operator are allowed to do.
Appendices
At the rear of the manual is a series of appendices that cover some of the technical
aspects of the Accessory, including the technical specification.
CHAPTER 1
QS Small Volume Sample Dispersion Unit
Page 1.4
MAN 0161
To Next Page
Loading...
