Malvern Instruments Mastersizer X - Moving the Accessory; Repackaging the Accessory

Moving the Accessory
If it is necessary to move the Accessory the following guidelines should be
followed:
.
Empty the Dispersion Unit.
.
Always disconnect the power supply before attempting to move the Con-
troller Unit. Disconnect the Controller Unit from the Dispersion Unit be-
fore attempting to move either the Controller Unit or the Dispersion Unit.
.
Always lift the Dispersion Unit by holding it under the base.
.
Never lift the Dispersion Unit by holding onto the motor cap, see diagram
below.
.
If the Dispersion Unit is to be moved large distances then it is recom-
mended that it is repackaged in its original packaging. To repackage the Dis-
persion Unit:
Repackaging the Accessory
Repackaging the Accessory is the reverse of the unpacking procedure described in
chapter 3. The packing procedure is summarised below:
.
Place the base foam insert into the base of the carton.
Small Volume Sample Dispersion Unit
INSTRUMENTS
Small Volume Sample Dispersion Unit
INSTRUMENTS
Small Volume Sample Dispersion Unit
INSTRUMENTS
Small Volume Sample Dispersion Unit
INSTRUMENTS
ILL 3058
CHAPTER 2
QS SMALL VOLUME SAMPLE DISPERSION UNIT Page 2.5