Malvern Instruments Mastersizer X - Disposing of the Accessory

.
Place the tank cover into a plastic bag, then place the cover into the tank of
the Dispersion Unit.
.
Wrap the sample tubing around the Dispersion Unit.
.
Wrap the Dispersion Unit in polythene and place it into its location in the
carton.
.
Place the following items into a padded bag:
User Manual.
Software installation.
Mains cable.
Digital I/O cable.
Place the bag on top of the Controller Unit and wrap in polythene.
.
Place the Controller Unit into its location in the carton.
.
Place the top foam insert in the carton.
.
Close and seal the carton with packing tape.
Disposing of the Accessory
When the need eventually arises to dispose of the Accessory, it should be done in
a responsible manner. The following are guidelines that should be followed:
.
Before disposal of the Accessory, it should be disabled in such a manner as
to make it impossible for it to be powered up. Seek advice from your local
Malvern representative for details.
.
The Accessory should be decontaminated if hazardous materials have been
used in it.
.
Refer to any local regulations on disposal of equipment.
CHAPTER 2 QS Small Volume Sample Dispersion Unit
Page 2.6 MAN 0161