Access to the Accessory
Within this manual reference is made to the various people that will have access to
the Accessory. Below is a list of these people and their responsibility:
Malvern personnel
Malvern personnel (service engineers, representatives etc.) have full access
to the Accessory and are authorised to perform all service procedures that
may be required.
Supervisor
The supervisor is the person responsible for the management/safety of the
System and of its operation. The supervisor is responsible for the training
of the operators. The supervisor can perform all user maintenance routines
identified in chapter 9, including changing the fuses.
Operator
An operator is a person trained in the use of the system. The operator can
perform all user maintenance routines identified in chapter 9, except
changing the fuses.
Systems covered by this manual
This manual covers the installation, operation and maintenance for the QS Small
Volume Sample Dispersion Unit. This accessory is used in association with
various Mastersizer optical units.
Mastersizer is a generic name given to a family of systems. Each system within the
family uses the same principles of operation and only vary in operation in small
areas. For this reason the manual has been written to cover more than one
instrument.
CHAPTER 1
QS SMALL VOLUME SAMPLE DISPERSION UNIT
Page 1.1
To Next Page
Loading...