water to the tank”, “add 7mg of sample” or “set the stirrer speed to 2500rpm”, that
will ensure the measurement is made consistently.
There are two macros that the operator should be aware of. The first (Qspec MS1
macro) is run when the button is pressed. This macro allows you to make a
measurement using an existing SOP or to create a new SOP.
The second macro can be run by selecting “Edit Qspec MS1 macro” from the
Control menu. This macro allows you to delete or amend an existing SOP.
'
Note
.
If the Qspec macro is not installed, consult appendix D.
CHAPTER 4
QS SMALL VOLUME SAMPLE DISPERSION UNIT
Page 4.5
To Next Page
Loading...
