Need help?Do you have a question about the mangOH Yellow and is the answer not in the manual?
Practices to prevent accidental damage to the mangOH Yellow, including ESD precautions.
Steps to download and install necessary drivers for the mangOH Yellow's CF3 module on Windows.
Steps for initial hardware and software setup, including dip switch verification and SIM card insertion.
Details on powering the mangOH Yellow via USB, expansion connector, or battery.
Instructions on selecting the primary power source using jumper pins on the mangOH Yellow board.
Steps to insert a micro-SIM card into the mangOH Yellow for mobile network connection.
Information about the micro-USB connector used for console access and the UART interface.
General| Storage | 4 GB eMMC |
|---|---|
| Wi-Fi | 802.11 b/g/n |
| Operating Temperature | -40°C to +85°C |
| Power Supply | 5V DC |
| USB Ports | 1 x USB 2.0 |
| Cellular | LTE |
| Bluetooth | Bluetooth 4.2 |
| GNSS | GPS, GLONASS, BeiDou, Galileo |
| Operating System | Legato |
| Interfaces | I2C, SPI, GPIO |
| Expansion Slots | Arduino |
| Processor | ARM Cortex-A7 |
To Next Page
