Manitowoc 18000 - Disconnect Jib Straps; Remove Jib Inserts and Top; Store Jib Strap Support Brackets; Remove Jib Butt

Reference Only
Manitowoc Published 12-05-17, Control # 032-23 4-115
18000 OPERATOR MANUAL SET-UP AND INSTALLATION
4
Disconnect Jib Straps
Reverse steps under Connect Jib Straps topic (page 4-107).
NOTE Disconnecting jib straps is not necessary if jib is not
being prepared for shipping.
Remove Jib Inserts and Top
Reverse steps under Install Jib Inserts and Top topic
(page 4-107
).
Store Jib Strap Support Brackets
Reverse steps under Install Jib Strap Support Brackets topic
(page 4-107
).
NOTE Storing support brackets is not necessary if jib is
not being prepared for shipping. Lay brackets (7)
back onto jib butt as shown in Figure 4-57
, View A4
and tie down before removing jib butt.
Remove Jib Butt
Reverse steps under Install Jib Butt topic (page 4-107).