Manitowoc 18000 User Manual

Reference Only
Manitowoc Published 12-05-17, Control # 032-23 3-49
18000 OPERATOR MANUAL OPERATING CONTROLS AND PROCEDURES
3
Operating Limits
Table 3-5 lists operating limits which can be displayed.
When one or more operating limit is reached, the operating
limit alert (yellow light and buzzer in cab) turns on to warn the
operator. Scroll to the crane faults/limits display screen. The
crane faults/limits screen (Figure 3-35
) automatically scrolls
through the active faults/limits, stopping at each for
approximately three seconds.
The operating limit alert turns off when the cause of limit is
corrected. Each active limit reached during operation is
retained in memory, until two things happen:
1. Name of limit appears on display at least once.
2. Cause of limit is corrected.
For this reason, it is normal for the inactive limits to appear
when you scroll to the operating limit group, even when the
operating limit alert is off.
To erase the inactive limits, scroll to the operating limit group.
Wait until the display scrolls through the name of each limit.
Inactive limits will be erased automatically. If the alert is on,
only the names of active limits will remain.
NO FAULT appears on the display (Figure 3-36
) when no
limits have been reached.
System Faults
Table 3-6 lists system faults which can be displayed.
When one or more system fault occurs, the system fault alert
(red light and beeper in cab) turns on to warn the operator.
Scroll to the crane faults/limits display screen. The screen
(Figure 3-37
) automatically scrolls through the active faults/
limit, stopping at each for approximately three seconds.
The system fault alert turns off when the cause of each fault
is corrected. Each active fault that has occurred during
operation is retained in memory, until two things happen:
1. Name of fault appears on display at least once.
2. Cause of fault is corrected.
For this reason, it is normal for the names of inactive faults to
appear when you scroll to the system fault group, even when
the system fault alert is off.
To erase the names of inactive faults, scroll to the system
fault group. Wait until the display scrolls through the name of
each fault. Inactive faults will be erased automatically. If the
alert is on, only the names of active faults will remain.
NO FAULT appears on the display (Figure 3-38
) when there
are no faults.
CRANE FAULTS/LIMITS
OPERATING LIMIT- BLOCK UP
FIGURE 3-35
CRANE FAULTS/LIMITS
OPERATING LIMIT- NO FAULT
FIGURE 3-36
CRANE FAULTS/LIMITS
SYSTEM FAULT- BOOM ANGLE SEND
FIGURE 3-37
CRANE FAULTS/LIMITS
SYSTEM FAULT- NO FAULT
FIGURE 3-38

Manitowoc 18000 Specifications

General

Brand	Manitowoc
Model	18000
Category	Construction Equipment
Language	English