EasyManuals Logo
Home>Manitowoc>Construction Equipment>Grove RT540E

Manitowoc Grove RT540E User Manual

Manitowoc Grove RT540E
160 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #54 background imageLoading...
Page #54 background image
SAFETY INFORMATION RT540E OPERATOR MANUAL
2-32 Published 01-15-2016, Control # 526-01
Stunt driving and horse-play are strictly prohibited. Never
allow anyone to hitch a ride or get on or off a moving crane.
Follow the instructions in this manual when preparing the
crane for travel.
If using a boom dolly/trailer, thoroughly read and understand
all the steps and safety precautions in this manual for setup
and travel.
When driving the crane, ensure the cab is down, if equipped
with a tilting cab.
Secure the hook block and other items before moving the
crane.
Watch clearances when traveling. Do not take a chance of
running into overhead or side obstructions.
When moving in tight quarters, post a signal person to help
guard against collisions or bumping structures.
Before traveling a crane, check suitability of proposed route
with regard to crane height, width, and length.
Never back up without the aid of a signal person to verify the
area behind the crane is clear of obstructions and/or
personnel.
On cranes equipped with air-operated brakes, do not attempt
to move the crane until brake system air pressure is at
operating level.
Check load limit of bridges. Before traveling across bridges,
ensure they will carry a load greater than the crane’s weight.
If it is necessary to take the crane on a road or highway,
check state and local restrictions and regulations.
Keep lights on, use traffic warning flags and signs, and use
front and rear flag vehicles when necessary. Check state and
local restrictions and regulations.
Always drive the crane carefully obeying speed limits and
highway regulations.
Stay alert at the wheel.
If equipped, ensure that the hoist access platform hand rail
and step are in the travel configuration.
Slopes:
- Pick and carry on level surfaces only.
- Refer to the Operation Section for more detailed
information on traveling on slopes.
- Driving across a slope is dangerous, as unexpected
changes in slope can cause tip over. Ascend or
descend slopes slowly and with caution.
- When operating on a downhill slope, reduce travel
speed and downshift to a low gear to permit
compression braking by the engine and aid the
application of the service brakes.
WORK PRACTICES
Personal Considerations
Always adjust the seat and lock it in position, and fasten the
seat belt securely before you start the engine.
Do not wear loose clothing or jewelry that can get caught on
controls or moving parts. Wear the protective clothing and
personal safety gear issued or called for by the job
conditions. Hard hat, safety shoes, ear protectors, reflective
clothing, safety goggles, and heavy gloves may be required.
Crane Access
You must take every precaution to ensure you do not slip
and/or fall off the crane. Falling from any elevation could
result in serious injury or death.
Never exit or enter the crane cab or deck by any other means
than the access system(s) provided (i.e., steps and grab
handles). Use the recommended hand-holds and steps to
maintain a three-point contact when getting on or off the
crane.
If necessary, use a ladder or aerial work platform to access
the boom nose.
Do not make modifications or additions to the crane’s access
system that have not been evaluated and approved by
Manitowoc Crane Care.
Do not step on surfaces on the crane that are not approved
or suitable for walking and working. All walking and working
surfaces on the crane should be clean, dry, slip-resistant,
and have adequate supporting capacity. Do not walk on a
surface if slip-resistant material is missing or excessively
worn.
Do not use the top of the boom as a walkway.
Do not step on the outrigger beams or outrigger pads (floats)
to enter or exit the crane.
Use the hoist access platform (if equipped) when working in
the hoist area.
Wear shoes with a highly slip-resistant sole material. Clean
any mud or debris from shoes before entering the crane cab/
operator’s station or climbing onto the crane superstructure.
Excessive dirt and debris on the hand-holds, access steps,
WARNING
Fall Hazard!
Working at elevated heights without using proper fall
protection can result in severe injury or death.
Always use proper fall protection as required by local,
state or federal regulations.
Reference Only

Table of Contents

Other manuals for Manitowoc Grove RT540E

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Manitowoc Grove RT540E and is the answer not in the manual?

Manitowoc Grove RT540E Specifications

General IconGeneral
BrandManitowoc
ModelGrove RT540E
CategoryConstruction Equipment
LanguageEnglish

Related product manuals