Manitowoc Grove RT540E - Page 64

SAFETY INFORMATION RT540E OPERATOR MANUAL
2-42 Published 01-15-2016, Control # 526-01
Overload less than 25%
1 Sheaves Inspect all for damage.
2
Luffing
Mechanism/
Cylinder
Inspect for damage/leaks.
3
Collar-wear
pads
Inspect all for damage.
Overload from 25% to 49%
1 Sheaves Inspect all for damage.
2
Luffing
Mechanism/
Cylinder
Inspect for damage/leaks.
3
Collar-wear
pads
Inspect all for damage.
4 Collar-welds Inspect all for cracks.
5
Telescopic
Sections
Inspect for bent or twisted sections. Check the boom
for straightness.
6
Lift Cylinder
Head Area
Inspect for bends or cracked welds.
7
Turret-Base
Section
Inspect for cracked welds.
8
Locking Area
(Pin Booms)
Inspect for elongated holes.
9 Welds Inspect for cracks.
10 Paint
Inspect for cracked paint which could indicate twisted,
stretched, or compressed members.
Reference Only