OPERATING CONTROLS AND PROCEDURES RT540E OPERATOR MANUAL
3-24 Published 01-15-2016, Control # 526-01
Stowing The Outriggers
NOTE: To enable outrigger functions, the crane must be in
four wheel drive, the parking brake must be
engaged and swing must be off.
1. Use the screen buttons or jog dial with the Outrigger
Function Enable Switch to select the left or right rear
outrigger on the CCS screen. Retract until the rear jacks
have retracted several inches.
2. Use the screen buttons or jog dial with the Outrigger
Function Enable Switch to select the left or right front
outrigger on the CCS screen. Retract until the front jacks
have retracted several inches.
3. Repeat steps 1 and 2 until the crane is resting on all
wheels and the jack floats are several inches off the
ground.
4. Release the locking levers and allow the floats to drop to
the ground. Continue to retract the jacks until they are
DANGER
Keep feet and hands clear of floats when unlocking the
floats from the jacks.
FIGURE 3-11
3
1 Outrigger Float Assembly
2 Quick Pin With Lanyard
3 Rubber Bumper
4 Cotter Pin
1
2
3
4
NOTE: Typical machine shown.Your machine may
appear different.
8699
Reference Only
To Next Page
Loading...
