216 Part Number 80-1230-9 10/10
Evaporator Re-Build Kits
An Evaporator Re-Build Kit is now available for out of
warranty Flake and Chiplet Ice Machine evaporators.
Defective in warranty evaporators must be replaced,
the warranty does not allow re-building. There are kits
for different sized evaporators as well evaporators that
may need the auger changed.
• Evaporators can only be re-built with the kit.
• When an evaporator is disassembled all parts
must be replaced.
• Parts are not available individually, only in kit form.
Included in the kit is a special tool that is required for
disassembly/reassembly. The tool is used for bearing
removal, proper seating of bearings and water seal.
IDENTIFYING CORRECT KIT:
The augers inside of the evaporators are stamped with
a letter, the letter indicates the date (A=2000, B=2001,
C=2002, etc.). Remove the top cap on the auger and
wipe off the grease to see the stamped letter. Use the
chart below to determine the proper kit.
Re-Build Kit Part Numbers
Stamped A or B
Model Re-Build Kit
Re-Build Kit
with Auger
QF400
Stainless Steel Evap
76-0166-3 76-0167-3
QC700 76-0168-3 76-0169-3
QF800 76-0168-3 76-0170-3
QF2300 76-0171-3 76-0172-3
All Others
Model Re-Build Kit
Re-Build Kit
with Auger
QF400 76-0166-3 76-0167-3
QC700 76-0166-3 76-0169-3
QF800 76-0166-3 76-0170-3
QF2300 76-0171-3 76-0172-3
To Next Page
Loading...
Need help?
General
