To Next Page

To Previous Page

Part Number 80-1230-9 10/10 33

INSTALLING ON A DISPENSER

Nugget ice is soft and chewable. This characteristic

makes this ice more difficult to dispense. All dispenser

manufacturers require a kit be installed for Nugget

type ice. Contact the dispenser manufacturer for the

correct adapter and nugget dispensing kit for your

specific model dispenser. The required kit can vary by

dispenser size from the same manufacturer.

Failure to install the correct kit and make the

necessary modifications on the dispenser will result in:

• Congealed ice which will not dispense and will

damage the ice machine and dispenser

• Insufficient ice contact with the cold plate which

will result in an inferior product

• A safety issue if ice lifts the adapter or ice machine

Nugget Dispensing Kit Installation Procedure

1. Follow the dispenser manufacturers instructions

for installation of the adapter (if required) and

nugget ice kit.

2. Make all necessary beverage, electrical and drain

connections to the dispenser.

3. Level the dispenser front to back and side to side.

4. Install ice machine on dispenser and secure ice

machine, dispenser and adapter with provided

brackets.

5. Complete water, drain and electrical connections

to the ice machine.

Warning

PERSONAL INJURY POTENTIAL

The ice machine and adapter must be attached to the

dispenser to prevent the ice machine from falling.

Caution

Ice machines in low volume locations may experience

congealing. Thermostat kit K00364 must be added in these

locations to prevent damage to the ice machine and dispenser.

Manitowoc QF0400 User Manual

Other manuals for Manitowoc QF0400