Part Number 80-1230-9 10/10 57
Cleaning And Sanitizing Procedure
QF0400
Cleaning and Sanitizing Procedure
Step 1 Set the toggle switch to the OFF position.
Open bin door and remove the 2 thumbscrews and
back evaporator panel.
Step 2 To start a cleaning cycle, move the toggle
switch to the CLEAN position. Water will flow through
the water dump valve and down the drain. The flush,
gear motor, speed, dump valve and water solenoid
lights will energize to indicate the ice machine is in the
cleaning mode.
Step 3 Wait about 1 minute or until the dump valve
light de-energizes. Lift the front cover on the reservoir
and add the proper amount of Manitowoc Ice Machine
Cleaner
.
Step 4 The ice machine will automatically time out
four Flush and Rinse cycles, and then stop. The Flush
light remains energized until the toggle switch is
moved to the OFF position. This entire cycle lasts
approximately 11 minutes.
NOTE: The ice machine may be set to start and finish
a cleaning procedure, and then automatically start ice
making again.
A. Wait about one minute into the cleaning cycle
(until the Dump Valve light de-energizes),
then move the switch from CLEAN to ICE
position.
B. When the cleaning cycle is complete, the
Flush light will turn off and ice making will
start automatically.
Model
Amount of Cleaner
Part Number 000000084
QF0400 2 oz. (60 ml)
To Next Page
Loading...
Need help?
General
