224 Part Number 80-1230-9 10/10
QC0700/QF0800
EVAPORATOR REMOVAL
The evaporator and motor / gearbox are separate
assemblies. Warranty procedures require replacement
of the entire evaporator or motor /gearbox assembly.
Field rebuilding during the warranty period is not
allowed.
1. Disconnect power to the ice machine.
2. Remove water level probes, water reservoir
cover, float valve, water reservoir, ice chute, and
drain tubing (refer to Component Removal).
3. Recover refrigerant and disconnect refrigeration
tubing from evaporator.
4. Remove foundation-coupling bolts.
5. Lift evaporator out of foundation coupling and
remove from ice machine.
6. Remove spline hub and keyway from evaporator.
7. After reinstallation of evaporator, torque
foundation bolts to 195-250 inch lbs.
To Next Page
Loading...
