64 Part Number 80-1230-9 10/10
Step 16 Refer to chart and premix the correct
solution of sanitizer and cool water for your model ice
machine.
Step 17 Remove the top cover from the ice chute and
pour the sanitizer/water solution into the evaporator.
Add the entire amount of premixed solution (excess
solution will exit through the overflow tube in the water
reservoir).
Step 18 Replace the ice chute cover and allow the
ice machine to stand for 30 minutes.
Step 19 Turn on the water supply to the ice machine.
Step 20 Move the toggle switch to the ICE position.
The compressor will energize and produce ice with the
sanitizing solution.
Step 21 The ice machine will freeze and discharge
the sanitizing solution into the bin. Allow the cycle to
run for 15 minutes.
Step 22 Discard all ice produced during the sanitizing
process.
Step 23 Place the toggle switch in the CLEAN
position. The ice machine will automatically time out a
series of flush and rinse cycles, and then stops. This
entire cycle lasts approximately 30 minutes.
Step 24 Refer to Disassembly For Cleaning/
Sanitizing for your specific model and remove, clean
and sanitize all parts listed.
Model
Amount of Sanitizer
Part Number
94-0565-3
Amount of Water
SN12
SN20
2 ounces (60 ml) 3 gallons (11.4L)
SF0400
SN0450
SF0600
SN0650
SF0900
SN0950
SF1200
SN1250
To Next Page
Loading...
Need help?
General
