40 Part Number: 040006847 12/19
Step 4 Mix 4 liters of water with 500 ml of cleaner/
descaler in a plastic or stainless steel container to prepare
a cleaning solution.
Cleaner/Descaler Water
500 ml (16 oz) 4 L (1 gal)
Step 5 Take all components to sink and with 2 liters
descaler/water mixture, descale all components with a soft
nylon brush. Disassemble the spray bar, remove nozzles
and inserts and soak for 5 minutes. For heavily scaled
parts, soak in the solution for 15-20 minutes. Rinse all
components with clean water.
Step 6 While components are soaking, use a nylon
brush to scrub the inside of the ice bin. Scrub inside of
the door, door track, bin, sump trough and evaporator
moldings. With clean water, rinse all of these areas
thoroughly.
Step 7 Replace the sump overflow tube and pour
remaining 2 liters of mixture into the water sump. Replace
all other parts.
Step 8 To start a cleaning cycle, press the toggle switch
to the WASH position and hold for 5 seconds.
Step 9 Wait until the clean cycle is complete
(approximately 13.5 minutes). Remove the water curtain,
ice chute and overflow tube from the water sump.
Allow all water to drain from the sump. Replace the
disassembled parts. Press the toggle switch to the WASH
position and hold for 5 seconds to start a 12 minute rinse
cycle.
To Next Page
Loading...
Need help?
General
