Part Number: 040006847 12/19 41
Step 10 After the rinse cycle is complete, remove the
water sump overflow tube. Drain water from the sump and
replace the tube. Mix 60 ml of sanitizer with 12 l of water
in a plastic or stainless steel container to make a sanitizing
solution.
Sanitizer Water
60 ml (2 oz) 12 L (3 gal)
Step 11 Remove all parts as described in “Component
Removal” on page 43.
Step 12 Take all components to sink and with 10 liters
(2.5 gal) sanitizer/water mixture, sanitize all components
with a soft nylon brush. Do not rinse the components.
Step 13 Use a nylon brush to sanitize the inside of
the ice bin. Scrub the inside of the door, door track, bin,
water sump, water distribution assembly and evaporator
moldings. Do not rinse.
Step 14 Replace the sump drain overflow tube and
transfer remaining 2 liters of solution into the sump
trough. Replace all other components.
Step 15 To start a sanitizing cycle, press the toggle
switch to the WASH position and hold for 5 seconds.
Step 16 Wait until the cycle is complete (approximately
13.5 minutes). Remove the water curtain, ice chute and
overflow tube from the water sump. Allow all water to
drain from the sump. Replace the disassembled parts.
Press the toggle switch to the WASH position and hold
for 5 seconds to start a rinse cycle. After the rinse cycle is
complete (approximately 12 minutes), remove the water
sump overflow tube, drain the water from the sump and
replace the tube.
To Next Page
Loading...
Need help?
General
