Mankati FULLSCALE XT PLUS - Page 26

www.mankati.com
24
Speed
-Travel Speed: Movingspeedwithoutprinting.Usuallysetting
at 70 is the best choice, Fullscale XT Plus can reach speeds of
250mm/satmost.Butthismaycausethemotormissingsteps
problem.
-Bottom layer speed: Thebottomprintspeed.Recommended
20,setas0meansthesameasotherlayer.Reducingthebottom
layerspeedcanhelpmodelstickmorecloselytoplatform.
-Infill speed: Speedatwhichinllpartsareprinted.
Recommended40withbestperformance.0meanssameprint
speedasotherlayer.Printingtheinllfastercangreatlyreduce
printingtime,butthiscannegativelyaffectprintquality.
Inner shell speed: Speedatwhichinnershellsareprinted.Ifset
to0thentheprintspeedisused.Printingtheinnershellfaster
thantheoutershellwillreduceprintingtime.Itisgoodtoset
thissomewhereinbetweentheoutershellspeedandtheinll
printingspeed.
-Top/bottom speed: Speedatwhichtop/bottompartsare
printed.Recommended25withbestperformance.0means
printingspeedisusedfortheinll.Printingthetop/bottomfaster
can greatly reduce printing time, but this can negatively affect
printquality.
-Outer shell speed: See function prompt in the software
-Inner shell speed: See function prompt in the software
Cool
-Minimal layer time: The minimal time of printing layer to ensure
enoughcoolingtimebeforeprintingnextlayer.Printspeedwill
adjustautomatictosatisfythisfeature.
Parameter Definition
-Enable cooling fan: enable cooling fan during printing to help
coollamentdown.