Getting
Started
Basic
Connections
Advanced
Connections
Basic
Operations
Advanced
Operations
Other
setting
Settings
Other
information
Explanation
terms
Troubleshooting Specifications Index
35
Settings
ENGLISH
Items Setting details
Reset Settings
Reset all settings to the
factory default except the
Parental settings, etc.
NOTE
“Parental” (vpage37) is not
reset.
1. Use
ui to select “Reset Settings”, then
press ENTER.
2. Use o p to select “Ok”, then press ENTER.
System
Network
Default settings are underlined.
• You can use a disc which offers BD-LIVE function by connecting the unit to the Internet (vpage27
“Connecting to the network”).
• When you set the communication setting manually, the following information of the connected router
or modem is required. Confirm the information prior to the setting : IP address, Subnet mask, Gateway,
Primary DNS and Secondary DNS.
Setting items Setting details
Wired
Configures network settings
depending on your internet
environment, etc. when
connecting to the internet.
NOTE
When IP Mode is set to Off,
Network Test cannot be
selected.
1. Use
ui to select “Wired”, then press ENTER.
2. Use ui to select “IP Mode”, then
press ENTER.
Off : Disables this unit’s LAN
capabilities.
Manual : Configures network
settings manually.
Dynamic : Automatically configures
the network settings by the DHCP
server function of the router or
modem.
Select “Manual” only when the
DHCP server function of the
router or modem cannot be used
for the automatic configuration.
3. Use ui to select the desired IP
mode, then press ENTER.
IP Settings
Link Status
MAC Address
IP Address
Subnet Mask
Gateway
Primary DHS
Secondary DHS
Link Up
Dynamic
00:23:03:00:50:b4
192.168.1.110
255.255.255.0
192.168.1.1
168.126.63.1
0.0.0.0
IP Mode
Apply Cancel
n When selecting “Off”
The values for IP Address, Subnet Mask, Gateway, Primary DNS and
Secondary DNS are all cleared.
Network
Setting items Setting details
Wired
(Continued)
n When selecting “Manual”
• You can select IP Address, Subnet Mask, Gateway, Primary DNS and
Secondary DNS to configure them manually.
• On the IP Settings menu, “Link Status” and “Mac Address” display
the corresponding information merely.
q Use ui to select the desired option, then press ENTER.
CancelOk
New value
Current value
Please enter a new IP Address.
192.168.1.110
w Enter the new value pressing 0 - 9, then press i to select “OK”
and press ENTER.
e Repeat the above steps q and w until other new values are all
entered.
r Use ui to select “Apply”, then press ENTER.
Then the network test is automatically performed and the result is
displayed.
t Press ENTER to confirm the test result.
The network menu will be displayed.
n When selecting “Dynamic”
Then the network test is automatically performed and the result is
displayed.
q Use ui to select “Apply”, then press ENTER.
Then the network test is automatically performed and the result is
displayed.
w Press ENTER to confirm the test result.
The network menu will be displayed.
Network Test
Detects the internet
connection and automatically
configures the network
settings by the DHCP server
function of the router or
modem.
1. Use
ui to select “Network Test”, then press
ENTER.
• Then the network test is automatically performed
and the result is displayed.
2. Press ENTER to confirm the test result.
The network menu will be displayed.
Cancel
Network Test
To Next Page
Loading...
