Marantz NR1506 /U1B - SURROUND MODES AND PARAMETERS; Sound Modes and Surround Parameters

SURROUND MODES AND PARAMETERS
Sound modes and channel output
S This indicates the audio output channels or surround parameters that can be set.
D This indicates the audio output channels. The output channels depend on the settings of “Speaker Config.”. (v
p. 159)
Sound mode
Channel output
Front L/R Center Surround L/R Subwoofer
Direct / Pure Direct (2-channel)
S Dz
Direct / Pure Direct (Multi-channel)
SDDD
Stereo
S D
Multi Ch In
SDDD
Dolby Pro Logic
g SDDD
DTS Neo:6
SDDD
Dolby Digital
SDDD
Dolby Digital Plus
SDDD
Dolby TrueHD
SDDD
DTS Surround
SDDD
DTS 96/24
SDDD
DTS-HD
SDDD
DTS Express
SDDD
Multi Ch Stereo
SDDD
Virtual
S D
z Audio is output when “Subwoofer Mode” in the menu is set to “LFE+Main”. (v p. 164)
Contents Connections Playback Settings Tips Appendix
209
Front panel Display Rear panel Remote Index
Sound modes and surround parameters
Sound mode
Surr.Parameter
Dialog Level Subwoofer Level Cinema EQ
Loudness Mngmt
z1
Dynamic Comp.
z2
Low Frequency
z3
Direct / Pure Direct (2-channel)z4 Sz5 SS
Direct / Pure Direct (Multi-channel)z4 SS SS
Stereo
S SSS
Multi Ch In
SSS S
Dolby Pro Logic g SSSSS
DTS Neo:6
SSSSS
Dolby Digital
SSS SS
Dolby Digital Plus
SSS SS
Dolby TrueHD
SSSSSS
DTS Surround
SSS SS
DTS 96/24
SSS S
DTS-HD
SSS S
DTS Express
SSS S
Multi Ch Stereo
SSSSSS
Virtual
S SSS
z
1 -
z
5 : “Sound modes and surround parameters” (v p. 212)
Contents Connections Playback Settings Tips Appendix
210
Front panel Display Rear panel Remote Index
Sound mode
Surr.Parameter
Tone
z6
Audyssey
M-DAX
z9
Pro Logic g Music mode only
Neo:6 Music
mode only
MultEQ®
z7
Dynamic EQ
z8
Dynamic
Volume
z8
Panorama Dimension Center Width Center Image
Direct / Pure Direct (2-channel)z4
Direct / Pure Direct (Multi-channel)z4
Stereo
SSSSS
Multi Ch In
SSSS
Dolby Pro Logic g SSS SSSSS
DTS Neo:6
S SSSSS
Dolby Digital
SSSS
Dolby Digital Plus
SSSS
Dolby TrueHD
SSSS
DTS Surround
SSSS
DTS 96/24
SSSS
DTS-HD
SSSS
DTS Express
SSSS
Multi Ch Stereo
SSSSS
Virtual
SSSSS
z
4,
z
6 -
z
9: “Sound modes and surround parameters” (v p. 212)
Contents Connections Playback Settings Tips Appendix
211
Front panel Display Rear panel Remote Index
z1
This item can be selected when a Dolby TrueHD signal is played.
z2
This item can be selected when a Dolby TrueHD, Dolby Digital or DTS signal is played.
z3
This item can be selected when a Dolby Digital or DTS signal or DVD-Audio is played.
z4
During playback in Pure Direct mode, the surround parameters are the same as in Direct mode.
z5 This setting is available when “Subwoofer Mode” in the menu is set to “LFE+Main”. (v
p. 164)
z6 This item cannot be set when “Dynamic EQ” is set to “On”. (v
p. 133)
z7
This item cannot be set when Audyssey
®
Setup (Speaker Calibration) has not been performed.
z8
This item cannot be set when “MultEQ
®
” is set to “Off”. (v p. 132)
z9
This item can be set when the input signal is analog, PCM 48 kHz or 44.1 kHz.
Contents Connections Playback Settings Tips Appendix
212
Front panel Display Rear panel Remote Index
66