The
Command (Unit of weight )
Use the
command to set the unit of weight:
1 Select a memory by using the arrow keys and .
2 Press the MENU key for a few seconds.
3 Select the
command with the arrow keys.
4 Press PRINT to display the currently active unit of weight
(the unit indicator to the right on the Weight Display lights
up).
5 Press PRINT a second time. The unit indicator starts to
blink, and you can now use the arrow keys to select a
different unit.
6 Press PRINT to confirm your selection, and press the
MENU key to return to Edit Mode where you can select
one of the other edit commands.
7 Press the MENU key a second time to return to Operating
Mode.
Note: When you change the unit of weight, the contents of the
and
limits are also converted.
For example,
=5 kg changes to 11.025 lb, 5 g to 0.015 lb, etc.
The
and
Commands (Lower/Higher limit)
Use the
and
commands to set the lower and upper weight limits:
8 Select a memory by using the arrow keys and .
9 Press the MENU key for a few seconds.
10 Select the
or the
command with the arrow keys.
11 Press PRINT . The memory’s current weight limits are
displayed on the Weight Display.
12 Press PRINT again. The first digit on the display starts to
flash, indicating that it can be changed to a new value.
13 Use the UP/DOWN arrows to change the value for the weight
limit digits. Press
PRINT to activate each digit.
Note: You must activate all digits (press PRINT six
times) or no change will take place.
14 Press the MENU key to return to Edit Mode where you
can select one of the other edit commands.
15 Press the MENU key a second time to return to Operating
Mode.
28 • Basic Operation M1100, U2 & C2-3.3
To Next Page
Loading...
