Edit Commands – Grading
For each grading memory you can specify a unit of weight and 9 lower
grade limits,
to
. The following table lists the edit commands
for the grading memories.
Table 2 Edit commands – Grading.
Command: Description:
Unit.
To set the unit of weight for the grades; kg, lb, g, or oz.
-
Lower grade limit.
To set the lower grade limit. Weighing results equal to or
above this value are accepted.
Grading method.
To select a grading method.
Net weight grading.
Normal grading.
Reverse grading.
Grading of decreasing weights. Optional recording.
Positive grading.
Grading of increasing weights. Optional recording.
Resolution (range).
To select single or multiple weighing range.
Automatic selection.
Automatic selection of weighing range.
Use Low.
Use lower weighing range; lower capacity.
Use High.
Use higher weighing range; higher capacity.
Single range scales
Note: To edit a memory, you must first select the memory you wish to
edit.
To edit a memory
1
Select a memory by using the arrow keys and .
2 Press the MENU key for a few seconds. The first available
editing command appears on the Config Display.
3 Select a command with the arrow keys and .
4 Follow the instructions for each command in the following
sections.
User’s Guide Basic Operation • 29
To Next Page
Loading...
