The
Command (Unit of weight)
Use this command to set the unit of weight for the selected grading
memory
. Follow the procedure described in “The UN Command” on
page 28.
The
Command (Lower Grade Limits)
The lower grade limits are set as follows:
1 Select a memory by using the arrow keys and .
2 Press the MENU key for a few seconds.
3 Select a grade limit (
to
) with the arrow keys.
4 Press PRINT . If available, the memory’s current grade
limits are displayed on the Weight Display.
5 Press PRINT again. The first digit on the display starts to
flash, indicating that it can be changed to a new value.
6 Use the UP/DOWN arrows to change the values of the grade
limit digits
. Press PRINT to activate each digit.
7 Press the MENU key to return to Edit Mode where you
can select one of the other grade limits.
8 Press the MENU key a second time to return to Operating
Mode.
Note: You must activate all digits (press PRINT six times) or no
change will take place.
Note: When you change the unit of weight, the contents of the grade
limit (
to
) is also converted.
For example,
=5 kg changes to 11.025 lb, 5 g to 0.010 lb, etc.
The
Command (Grading Method)
Use this command to select a grading method for the selected memory.
1 Select a memory by using the arrow keys and .
2 Press the MENU key for a few seconds.
3 Select the
command with the arrow keys.
4 Press PRINT . The currently active grading method, ,
or , is displayed on the Weight Display.
5 Press PRINT again. The grading method starts to flash,
indicating that it can be changed to a new value.
6 Use the UP/DOWN arrows to change the grading method.
30 • Basic Operation M1100, U2 & C2-3.3
To Next Page
Loading...
