Marel M1100 - Appendices; Appendix A: Error Codes

Appendices
Appendix A  Error codes
Error code: Description: Action:
E-03
ADC overrange Reduce the weight on the
platform
E-04
ADC underrange Increase the weight on the
platform
E-05
Unstable weight (initial zero) Stabilize the scale
E-06
Weight outside range (initial zero) Make sure the platform is
empty
E-08
Operation in progress (initial zero) Wait until completed
E-11
Invalid initial zero Remove or reduce the
weight on the platform
E-13
Program failure (checksum) Contact your Marel agent
E-14
ADC not responding Contact your Marel agent
E-15
W&M setup checksum failure Contact your Marel agent
E-23
24 V power voltage too high Provide correct voltage
E-25
Low voltage to load cells Check load cell
E-81
Invalid static marine calibration.
Fit value too high
Repeat calibration
E-82
Invalid static marine calibration.
Calibration weight not detected
Repeat calibration
E-84
Marine static calibration not allowed Scale requires motion
E-91
Invalid marine calibration. Fit value
too high
Repeat calibration
E-92
Invalid marine calibration.
Calibration weight not detected
Repeat calibration
E-93
Invalid initial zero Make sure the platform is
empty
Note: If the error persists contact Marel hf. or your local Marel agent
for assistance.
User’s Guide Appendices • 39