*STROBE from above pics. is in case of ASCII communication. In case of model selection,
it is recognized PLC7*
09:30:31 : Indicate the current time
0.00 : The cycle time of previous marking data (unit: sec)
STATUS : Indicate the status of marking machine
[ BLOCK ] : In case of marking using PLC START
[ MARKING ] : In case of marking using common START
[ END RUN ] : : In case marking is done
[ EMER STOP ] : It gets the signal “Emergency stop” of PLC and error of the working
[ LIMIT ERROR ] : Limit error
[ Y-DRV.FAULT ] : When the cable of Y-axis motor is cut
[ X-DRV.FAULT ] : When the cable of X-axis motor is cut
[ UNIT END ] : When the specified marking quantity is done
CUSOR_MOVE : ENTER : Moving the cursor and saving the data is the Enter key on the keyboard.
SELECT:SPACE_BAR : Can change the mode of marking by Space_Bar on the keyboard .
F9:SIMULATION : Simulation
F10 :MARK : Real marking
F11:HOME: Return to home position.
To Next Page
Loading...