: Select marking type. Press SPACE BAR to change the Menu
EMT : Empty block (Default value)
LIN : Linear marking.
CIR : Circular marking.
PLT : Logo file marking after loading CAD file.
CYL : Cylinder marking.
2DM : 2D Data matrix marking
X : Center of circle for X axis from Zero point (30mm is X:0300 <Unit : 0.1mm>
Y: Center of circle for Y axis from Zero point (30mm is X:0300 <Unit : 0.1mm>
R: When it`s ARC marking, a radius from center to start point of marking (Radius 12mm is R:0120)
<Unit 0.1mm>)
A: Select the marking start degree ( 50 º is A:050.)
D(Direction) : W+(can select the marking direction)
W +: To move the marking start point the clockwise.
W -: To move the marking start point the counterclockwise.
Key: Press +, - or SPACE BAR
To Next Page
Loading...