Marksman MCU-100N User Manual

24
L : It doesn`t impact to the PLT file marking.
I: It doesn`t impact to the PLT file marking.
P : P is pause
P: Y = The pin wait for the next signal after last letter is marked.
(To wait for next time start signal) Not output END signal
P: N = The pin returns back to home automatically.
l *Remark*
Moving the block on the single block mode : (↓,↑)
Moving the block on the multi block : First 2 main block (Pagn Down, Pagn Up) Last 2 block : (↑,↓)
9
10
11
PAUSE:N 일경우 PAUSE:Y 일경우
마킹완료후 원점위치로
자동복귀
마킹완료후 마지막 마킹위치
에서 신호(Ex.START 또는 RESET )
대기
Stop after marking at
the last marked position
Return to Home position
after marking automatically

Marksman MCU-100N Specifications

General

Brand	Marksman
Model	MCU-100N
Category	Controller
Language	English