F4 Screen : Block and sequence data, store and load of setup information.
If press “F4” on the KEY BOARD, it is changed like MARKING DATE LOAD => MARKING DATA SAVE =>
SEQUENCE FILE LOAD => SEQUENCE FILE SAVE => ALL SETUP LOAD => ALL SETUP SAVE
<MARKING DATA LOAD >
The function, that in advance stored marking data, load to the SD memory card.
At LOAD screen, if you press the direction key, be shown the marking data list of SD card.
After find the file you want and press “enter”, it will start to load, If loading is finished normally
Will be shown the message “LOAD DATA OK” on the status screen
.
<MARKING DATA SAVE>
The function that stored marking data in controller stores to the SD card.
Storing is the backup function of the data. When the data was disappeared by an error of the controller
and interruption of electric power, you can use that function.
Storing finish normally, will be shown the message “SAVE DATA OK” on the status screen
To Next Page
Loading...
Need help?
General